| |
PW2110
|
PW2120
|
|
Frequency Characteristics
|
-
Waveforms Sine Square Triangle, ± Pulse
± Ramp
-
Range 0.1Hz to 10MHz in 8 ranges
-
Resolution 5 digits
-
Frequency stability 0.1%
-
Tuning Range - Coarse 10:1, Fine ±5% of
Coarse Setting
-
Variable Duty Cycle 15:85:15 Continuously
Variable.
-
Operating Modes - Normal, Sweep, VCG
|
-
Waveforms Sine Square Triangle, ± Pulse
± Ramp
-
Range 0.2Hz to 20MHz in 8 ranges
-
Resolution 5 digits
-
Frequency stability 0.1%
-
Tuning Range - Coarse 10:1, Fine 1/16%
of Coarse Setting speed
-
Variable Duty Cycle 15:85:15 Continuously
Variable
-
Operating Modes - Normal, Sweep, VCG,
AM, FM, Burst
|
|
Output Characteristics
|
-
Impedance 50 ohm ±10%
-
Level 20v p-p Open Circuit, 10v p-p into
50 ohm
-
Amplitude; variable 20dB range typical
-
DC Offset Preset ±0.1v Variable ±10v open
circuit, ±5v into 50 ohms
-
Auto + negative peak of waveform 0v ±
0.1v
-
Auto - positive peak of waveform 0v ±
0.1v
|
-
Impedance 50 ohm ±10%
-
Level 20v p-p Open Circuit, 10v p-p into
50 ohm
-
Amplitude; variable 20dB range typical
-
DC Offset Preset ±0.1v Variable ±10v open
circuit, ±5v into 50 ohms
-
Auto + negative peak of waveform 0v ±
0.1v
-
Auto - positive peak of waveform 0v ±
0.1v
|
|
Sine Wave
|
|
|
|
Square Wave
|
- Symmetry 0.1Hz to 100kHz <2%
- Rise Time 20ns
|
- Symmetry 0.2Hz to 100kHz <2%
- Rise Time 20ns
|
|
Triangle Wave
|
Linearity >98% to 100kH
|
Linearity >98% to 100kH
|
|
TTL Output
|
- Level 0.8v 2.4v
- Rise Time <20nS
- Duty Cycle 50% typ
|
- Level 0.8v 2.4v
- Rise Time <20nS
- Duty Cycle 50% typ
|
|
CMOS Output
|
- Level 0-4v to 0-14v Continuously variable
- Rise Time <120ns
- Operation unspecified at frequencies > 2MHz
|
- Level 0-4v to 0-14v Continuously variable
- Rise Time <120ns
- Operation unspecified at frequencies > 2MHz
|
|
VCG (Voltage Controlled Generator Input)
|
|
|
|
Sweep Operation
|
-
Mode Linear or Log
-
Width 100:1 continuously variable
-
Rate 20ms to 30s continuously variable
-
Sweep output 0-2v
-
Start/stop frequencies adjustable
|
-
Mode Linear or Log
-
Width 100:1 continuously variable
-
Rate 20ms to 30s continuously variable
-
Sweep output 0-2v
-
Start/stop frequencies adjustable
|
|
Amplitude Modulation Characteristics
|
|
-
Source Internal or External
-
Modulation Depth 0-100%
-
Internal Modulation 1kHz
-
External Modulation DC to 500kHz
-
External Sensitivity < 10v for 100% modulation
|
|
Frequency Modulation Characteristics
|
|
-
Source Internal or External
-
Deviation 0-5%
-
Internal Modulation 1kHz
-
External Modulation DC to 500 kHz
-
External Sensitivity < 10v for 5% deviation
|
|
Burst Characteristics
|
|
- Source Internal/External
- Burst Width Continuously Variable from 5% to 90% of
burst repetition rate
- Repetition Rate 0.5Hz internal, DC to 500kHz external
- External Level: TTL levels
- Burst Frequency: Same as Main Generator frequency
- Burst is always an integral number of cycles, starting
and finishing at zero crossing
|
|
Frequency Counter
|
|
|
|
External Input
|
- Frequency range 5Hz to 40 MHz,
- Resolution 0.1Hz, 1Hz, 10Hz 100Hz 1kHz, automatically
switched depending on input frequency
- Sensitivity < 25mV rms
- Impedance 1M ohm/ 100pF
|
- Frequency range 5Hz to 40 MHz,
- Resolution 0.1Hz, 1Hz, 10Hz 100Hz 1kHz, automatically
switched depending on input frequency
- Sensitivity < 25mV rms
- Impedance 1M ohm/ 100pF
|
Square Wave divide by 10 or 100
|
Auxiliary square wave outputs at 1/10th and
1/100th of the main frequency. -TTL levels
|
Auxiliary square wave outputs at 1/10th
and 1/100th of the main frequency. -TTL levels
|
|
Power Source
|
110/230v ac 50/60H
|
|
|
Communication Port
|
RS-232
|
|
